I recommend that you use the Intel raid controller. Does one offer better throughput? It will silently load these drivers and display the target device. As for the 6 yellow ones, they seem to be in 3 pairs. Use the SB or Gigabyte’s cntroler Moderators: I currently have Vista x32 installed on Gigabyte Raid 0 there’s also an intel raid option but i’ve never used it. The problem I have is that i cannot seem to load the raid drivers.
|Date Added:||5 June 2004|
|File Size:||51.46 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Raid 0 setting up GA-PDS3R – – An Overclocking Community
It would burn my finger. Next you will be taken to this screen where you will be able to create your raid 0: Remove Advertisements Sponsored Links. We’re combining two older computers into a data server for the office – it’ll have two GB drives in raid 0, and two gB drives in raid 0, ga-p35-fs3p a 2 TB for weekly backups. Then use the two larger drives in RAID1 and use that to store your data.
Micron chip, both of which is software based raid. Ensure that the disk’s controller is enabled in the computer’s BIOS menu. Page 1 of 1. I also think my IDE port is run through this chip also. Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. A single disk rzid in a stripe results in complete loss of all data.
I have in the past had dual boot, in separate partitions, with xp, linux and windows server, all without problems with the raid drivers.
Suspicious Activity Detected
Does anyone know if this is an issue with this driver or does anyone have a link to another driver? I was considering getting the same board and doing the same thing but was equally clueless and this has been GREAT.
This is my first time configuring a RAID array and if anyone could give me any help it would be greatly appreciated. When I get to the “Where do you want to install Windows?
Here Is something that might be related – Win 7 won’t install with 4GB of system memory. I opted to put a couple of mosfet heatsinks on it. When you try to load the third party drivers “Load Drivers” option and select the 64 bit drivers, the WPE doesn’t see any ga-p35-fs3p bit drivers and pops up the message about the drivers do not apply to your system or are unsigned. I assume these files are at least mildly ga-p35-dsp3 if you plan weekly backups.
Find More Posts by fluffyalien. I’m yet to work in any organisation where any data loss is considered acceptable. Last but not least, did you purchase HS’s for these little puppies or did you fabricate them yourself?
Here is the link for the drivers your motherboard has a jmb36x: Here’s the guide I found: I am using the Intel raid and it works flawlessly. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build.
Note that passwords are case-sensitive.
GIGABYTE GA-P35-DS3P RAID Setup?
To further confuse things WPE may see the 32 bit drivers if they are in the same directory you specify as having the ones for x Sat Dec 29, Previous topic Next topic. Striping data is asking for trouble if the data is of ANY significance to your organisation. The Gigabyte controller is there to provide an IDE connector because the newest Intel southbridges don’t have one.